-
Audi lover
Assistenza alla partenza
Forse ci siamo, leggendo attentamente la codifica/lettura stato della centralina 0x53 (Parking brake) ho trovato questo:
Function description, reading measured value block
Measured value block 001:
J System configuration
JPad change mode Status display bit 0=0 left brake open; bit 1=0 right brake open
J Maximum ECD deceleration (2-8 m/sІ)
J Gearbox type (manual bit 7 = 0, automatic bit 7 = 1) Bit 0-6 not used, always 1
Bit description: System configuration:
Bit 0: Readiness Bit Assembly Check; set at basic setting 10
0: OK (default) / 1: n.OK
Bit 1: Readiness Bit System Calibration; set at basic setting 20
0: OK (default) / 1: n.OK
Bit 2: Airbag seat belt buckle DAA
1: On (default)
0: Off
Bit 3: Starting-off aid
0: With / 1: Without (depending on coding)
Bit 4: Pad change mode
1: MAN_MAINTENANCE_MODE
present (constant "1")
Bit 5: RWU-ECD functionality
0: ECD active (default)
1: RWU active
Bit 6: Open with brake pedal
0: Opening possible without brake pedal
1: Opening only with brake pedal (default)
Bit 7: VM-EOL-Bit
0: Vehicle successfully coded
1: EOL not complete
Description of pad change mode:
Bit 7: 0 = Maintenance mode active
Bit 0-Bit 6: Not used, always "1"
La parte in NERETTO, ovvero il Bit 3 mi fa pensare che sia il famoso Hill-Start .... che ne pensate ?
Enry
-
-
-
Audi lover
Si vede che non hai un CAXXO da fare..........
aggiungo, naturalmente scherzo...................
Ultima modifica di alexx; 08-07-2011 alle 17:58
-
-
Audi lover
Veramente no, solo che a differenza di altri il mio poco tempo libero lo passo con ciò che mi diverte.
-
-
Audi lover
enry purtroppo sei uno dei pochi con a6 rest.. noi pre non abbiamo modo di verificare..
-
-
Audi lover
-
Permessi di Scrittura
- Tu non puoi inviare nuove discussioni
- Tu non puoi inviare risposte
- Tu non puoi inviare allegati
- Tu non puoi modificare i tuoi messaggi
-
Regole del Forum
Segnalibri